Saturday, October 3, 2015

Update - 10/03/15

Lot's of progress being made by the Opel sub teams! 

Here are some of the things members did this week:
  • Installed and began learning KiCad
  • Began schematic capture for CAN dev board 
  • Characterized hub motors for voltage, frequency parameters
  • Took measurements of stepper motor dimensions for PCB footprints 
  • Installed and began learning SolidWorks
  • Began mockup of front compartment and cooling system
  • Set up firmware and hardware templates for electrical subsystems
  • Learned about CAN communications
  • Got two LPC uControllers talking to each other over CAN bus

No comments:

Post a Comment